Bernie (NoVA) Posted July 30, 2012 Report Posted July 30, 2012 I'm installing a set of factory Xenon head lights on my 2006 R53. This weekend I had a chance to take care of some maintance items around the car. Since I had the wheels off for swapping out brake pads and installing strut tower reinforcement plates (steel plate inside the wheel well, M7 aluminum on top) and knocked out the studs in the factory hats and replaced w. longer grade 10.9 hardware to lock it all in place... anyway. Wheels off so I installed the driver side washer bottle & pump for the head lights. Good news was that I got that installed with out having to remove the exterior fender. Question at hand is what is the best way to wire this into the washer controls? Is there a factory sub harness that I can buy? I do have a wire pigtail/connector for the pump so I can extend that to reach what I need. Strut plates in place, bottle installed Washer hoses routed under hood liner 2006 R53 6 Speed with Aero British Racing Green ------------------------------------------ [sIGPIC][/sIGPIC]
